Ericsson Internal
DIRECTIONS FOR USE
3 (11)
Prepared (also subject responsible if other)
No.
EUS/WR/EA Dilip Garapaty
1553 - HSM 901 3219 UEN
Approved
Checked
Date
Rev
Reference
EUS/WR/EA [Stacy Scott]
2014-11-17
A
The customer edge router can be configured with a static route tracking
feature to track the availability of the static route to the primary ISP.
In case of a failure in the static route to the primary ISP, the static route
tracking feature will remove it from the routing table and replace it with a
backup route.
Please refer to your specific router admin guide on how to configure static
route tracking.
This document provides details on how to configure the K530S in bridge
mode as well as how to configure the edge router with a static route to the
K530S.
Note: The configuration is for redundancy or backup purposes only and
not for load sharing across the two interfaces. Outgoing traffic uses the
primary ISP and then the secondary ISP, if the primary fails. Failure of the
primary ISP causes a temporary disruption of traffic.
3
Components
The following components are required for this redundant connection for
business continuity:
•
Edge router with at least one available outside L3 Ethernet
interface to connect to K530S router and for configuring the
redundant route to the internet
•
K530S LTE router activated on Sprint 4G LTE network with a
dynamic routable IP
•
Connection from ERDM (Ericsson Remote Device Manager)
to the K530S over the Sprint NW via the assigned dynamic IP
4
Instructions
4.1
K530S in Bridge mode via local connection
Connect to the K530S over the laptop Ethernet interface and launch the
browser to
http://192.168.1.1
Login to the K530S administration GUI using the provided credentials.
Template: D1713
