B&R PROVIT 4000, Руководство пользователя

Страница: 22 / 100

2 2
2.4.2 OPERATION WITH TWO HARD DISKS
1) Pull the power plug.
2) Insert hard disk 1 in the master slot (see Section "4.4 Hard Disk"). The drive designation is c:
3) Insert hard disk 2 in the slave slot. The drive designation is d:
4) Reinsert power plug.
5) Enter BIOS Setup:
Entering BIOS Setup is done during the system RAM check. The BIOS start -up message indicates which
key has to be pressed (mostly [Del], it is another key for controllers with a Pentium processor).
6) Determine hard disk type.
This set is not required for the controller 5C4000.04, since the Pentium processor determines the hard disk
type automatically.
For other controllers, the menu item "Auto Detect Hard Disk" or "IDE HDD Auto Detection" (5C4000.03)
must be selected and started.
The following messages "Accept Parameters for C: (Y/N) ? N" and "Accept Parameters for D: (Y/N) ? N"
are to be answered [Y].
7) Set date and time if necessary.
Select the menu item "Standard CMOS Setup". After the [
↵
] key has been pressed again, the date and time
can be set.
Exit this function with the [Esc] key.
8) Insert the first operating system disk.
9) Exit BIOS Setup:
Select the menu item "Write to CMOS and Exit". The message "Write to CMOS and Exit (Y/N) ? N" is to
be answered with [Y].
10) The PC reboots.
11) The operating system is automatically installed. Please read the notes that appear on the screen.