Bandit ZT1844, Инструкция по эксплуатации и каталог запасных частей

Страница: 32 / 102

Bandit
30
Copyright 12/18
MODEL ZT1844 MAINTENANCE
Each day before starting your machine these checks must be made:
DAILY START UP & MAINTENANCE CHECK LIST
1. Check the safety decals and engine gauges, replace if damaged.
2. Check, maintain, and service all safety equipment for proper operation.
3. Check entire machine for loose nuts, bolts, and components.
4. Check all guards to make sure they are tight and securely in place.
5. Check the condition of the cutter wheel and teeth pockets.
6. Check the condition of the cutter teeth, pockets, and hardware.
7. Properly torque cutter wheel pocket bolts.
8. Grease cutter wheel and jack shaft bearings daily - purge
9. Grease slew ring bearing daily - purge.
10. Clean debris from beltshields.
11. Check / adjust the drive belt, cutter wheel belt, and pump belt tension and alignment.
12. Check and always maintain hydraulic level at 3/4 to 7/8 full.
13. Check all hoses, fittings, lines, and tanks for damage and fluid leaks.
14. Check hydraulic control valves and ensure they operate and shift correctly.
15. Check fuel level. (Running out and repriming is time consuming).
16. Check engine oil, coolant levels, and correct engine speed. Follow ENGINE
MANUFACTURER’S manual specs.
17. Check radiator and debris screen. Clean as necessary. Clean cooling fan and
shroud on air cooled engines.
18. Check air cleaner, precleaner, and vacuator valve. Clean as necessary.
19. Check track assembly for wear and damage. Repair or replace as necessary.
Check the rubber track tension (1/2” deflection with 100 lbs. of force).
20. Check around the entire machine for any foreign objects, tools, cans, saws, etc.
21. Review all safety procedures on decals, from manual, and from video.
22. Wear all applicable safety equipment: hard hat, face shield, gloves, eye
protection, ear protection, etc.
23. Remember to check EVERYTHING on the checklist.
OK REPAIRED
WEEKLY CHECK LIST
1. Grease cylinder lug pin bushings with 1 - 2 shots.
2. Lubricate steel friction areas: pivoting, hinged, sliding, & rotating areas
(i.e. cutter wheel guard, control box doors, etc.).
3. Check set screws in bearings.
4. Check alternator and fan belts on engine, adjust, or replace.
Every week these checks must be made:
OK REPAIRED
1. Check grinder bearings and grinder sheaves.
2. Check bearing and bearing lock collars.
3. Check hydraulic function pressures. Set to specified PSI (bar).
4. Check and retorque the slew ring bearing bolts.
MONTHLY CHECK LIST
Every month these checks must be made:
OK REPAIRED
1. Replace hydraulic filter(s) after first 10 hours then quarterly or every 400 hours.
Located in the hydraulic tank.
3 MONTH CHECK LIST
Every three months these checks must be made:
OK REPAIRED