B&G Vulcan R, Руководство по установке

Страница: 53 / 72

1.
Set the internal wireless to
Access Point
mode. To do this,
select the
Wireless devices
page in the Wireless settings
dialog and then select the unit's Internal Wireless. Next, select
the
Mode
option and then select
Internal Access Point
.
2.
Select the Internal Wireless device on the
Wireless devices
page to view its Network Key.
3.
Navigate to the wireless network connection page on the
smartphone, and find the unit or GoFree wireless
xxxx
network. If
more than one is in range, review the
Wireless devices
page
from the unit's Wireless settings dialog to confirm which
wireless device is connected to the unit.
4.
Enter the Network Key in the smartphone to connect to the
network.
5.
Open the GoFree application on the smartphone, the unit
should be automatically detected. The name displayed will be
either the default, or that assigned in the Device Name setting. If
the unit does not appear, follow the on screen instructions to
manually find the device.
The MFD's display is shown on the smartphone. To change the
MFD's display on the smartphone, use the MFD to change the
display on the MFD. The display change on the MFD is reflected on
the smartphone.
Remote controllers
When a wireless device is connected, it should appear in the
Remote controllers
list.
Selecting
Always allow
means the device can automatically
connect without needing a password each time. This menu also
allows disconnection of devices that no longer require access.
Wireless devices
This dialog shows the internal wireless and any connected WIFI-1
devices, as well as their IP and channel number. Selecting the
internal wireless or a WIFI-1 device provides additional detail.
Ú
Note:
WIFI-1 is possible with the 7", 9" and 12" unit only, using
the Radar/Ethernet connection on the back of the unit.
To view and change internal wireless detail values (Network name
(SSID), Network key, or Channel) the internal wireless must be in
Access Point
(Internal Wifi) mode. To select a network (hotspot) to
connect to, the internal wireless must be in
Client Mode
.
Software Setup | Vulcan R Series Installation Manual
53