B&G Vulcan 12, Инструкция по эксплуатации

Страница: 51 / 68

Calibration
An offset (positive or negative) can be applied to correct data
inaccuracies from NMEA 2000 sources. The offset is set on the NMEA
2000 device.
Ú
Note:
Select the advanced option to adjust local offsets for this
display only.
Ú
Note:
It is typically not possible to calibrate 3rd party sensors.
However, a local offset can be applied.
NMEA 2000 setup
Receive waypoint
Allows waypoints to be received from devices that transmit a
waypoint over the NMEA 2000.
A waypoint will be received when the waypoint is created on the
other device, if the following settings are in place:
• The receiving device - the receive waypoint option must be set
to ON before the waypoint is created in the sending device.
• The sending device - the send waypoint option must be set to
ON before the waypoint is created.
Send waypoint
Allows this unit to send a waypoint to other devices over the NMEA
2000 network.
A waypoint will be transmitted when the waypoint is created, if the
following settings are in place:
• The sending device - the send waypoint option must be set to
ON before the waypoint is created.
• The receiving device - the receive waypoint option must be set
to ON before the waypoint is created in the sending device.
Ú
Note:
The system can only transmit or receive one waypoint at
a time over the NMEA 2000 network. For bulk import or export
of waypoints see the operator manual.
System setup | Vulcan Series Installation Manual
51