[ 0.133939] VFS: Disk quotas dquot_6.5.2
[ 0.134207] Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
[ 0.135970] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[ 0.135994] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[ 0.136719] msgmni has been set to 1490
[ 0.138903] bounce: pool size: 64 pages
[ 0.138931] io scheduler noop registered
[ 0.138946] io scheduler deadline registered
[ 0.138996] io scheduler cfq registered (default)
[ 0.139318] platform 1c13400.phy: Driver sun4i-usb-phy requests probe deferral
[ 0.142025] sun7i-a20-pinctrl 1c20800.pinctrl: initialized sunXi PIO driver
[ 0.184985] Serial: 8250/16550 driver, 8 ports, IRQ sharing disabled
[ 0.187319] console [ttyS0] disabled
[ 0.207743] 1c28000.serial: ttyS0 at MMIO 0x1c28000 (irq = 33, base_baud = 1500000) is a U6_16550A
[ 0.828354] console [ttyS0] enabled
[ 0.854828] 1c28c00.serial: ttyS1 at MMIO 0x1c28c00 (irq = 36, base_baud = 1500000) is a U6_16550A
[ 0.886744] 1c29c00.serial: ttyS2 at MMIO 0x1c29c00 (irq = 52, base_baud = 1500000) is a U6_16550A
[ 0.899279] platform 1c50000.ethernet: Driver stmmaceth requests probe deferral
[ 0.906754] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
[ 0.913282] ehci-platform: EHCI generic platform driver
[ 0.918683] platform 1c14000.usb: Driver ehci-platform requests probe deferral
[ 0.926000] platform 1c1c000.usb: Driver ehci-platform requests probe deferral
[ 0.933320] ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
[ 0.939546] ohci-platform: OHCI generic platform driver
[ 0.944901] platform 1c14400.usb: Driver ohci-platform requests probe deferral
[ 0.952185] platform 1c1c400.usb: Driver ohci-platform requests probe deferral
[ 0.959587] usbcore: registered new interface driver usb-storage
[ 0.965867] mousedev: PS/2 mouse device common for all mice
[ 0.971551] 1c22800.lradc supply vref not found, using dummy regulator
[ 0.978474] input: 1c22800.lradc as /devices/soc@01c00000/1c22800.lradc/input/input0
[ 0.991771] axp20x-regulator axp20x-regulator: regulators node not found
[ 0.998630] LDO1: 1300 mV
[ 1.001767] LDO2: at 3000 mV
[ 1.005157] LDO3: at 2275 mV
[ 1.008294] LDO4: at 2800 mV
[ 1.011695] LDO5: at 2800 mV
[ 1.015085] DCDC2: at 1400 mV
[ 1.018533] DCDC3: at 1250 mV
[ 1.021668] axp20x 0-0034: AXP20X driver loaded
[ 1.027508] sunxi-wdt 1c20c90.watchdog: Watchdog enabled (timeout=16 sec, nowayout=0)
[ 1.036066] sunxi-mmc 1c0f000.mmc: No vqmmc regulator found
[ 1.041994] sunxi-mmc 1c0f000.mmc: Got CD GPIO
[ 1.084877] sunxi-mmc 1c0f000.mmc: base:0xf00fa000 irq:64
[ 1.092685] sunxi-ss 1c15000.crypto-engine: Die ID 0
[ 1.099853] TCP: cubic registered
[ 1.103201] Initializing XFRM netlink socket
[ 1.107611] NET: Registered protocol family 17
[ 1.112178] bridge: automatic filtering via arp/ip/ip6tables has been deprecated. Update your scripts to load br_n
etfilter if you need this.
[ 1.124806] 8021q: 802.1Q VLAN Support v1.8
[ 1.129125] Registering SWP/SWPB emulation handler
[ 1.134455] registered taskstats version 1
[ 1.139223] ahci-5v: 5000 mV
[ 1.142597] usb1-vbus: 5000 mV
[ 1.147273] usb2-vbus: 5000 mV
[ 1.150752] gmac-3v3: 3300 mV
[ 1.192892] mmc0: host does not support reading read-only switch, assuming write-enable
[ 1.203577] mmc0: new high speed SDHC card at address 0001
[ 1.209591] mmcblk0: mmc0:0001 00000 7.44 GiB
[ 1.215221] mmcblk0: p1 p2
[ 1.264746] stmmaceth 1c50000.ethernet: no reset control found
[ 1.270578] Ring mode enabled
[ 1.273630] No HW DMA feature register supported
[ 1.278179] Normal descriptors
[ 1.281500] TX Checksum insertion supported
[ 1.292504] libphy: stmmac: probed
[ 1.295950] eth0: PHY ID 03625f24 at 0 IRQ POLL (stmmac-0:00) active
[ 1.302298] eth0: PHY ID 03625f24 at 1 IRQ POLL (stmmac-0:01)
[ 1.308050] eth0: PHY ID 03625f24 at 2 IRQ POLL (stmmac-0:02)
[ 1.313789] eth0: PHY ID 03625f24 at 3 IRQ POLL (stmmac-0:03)
[ 1.319538] eth0: PHY ID 03625f24 at 4 IRQ POLL (stmmac-0:04)
[ 1.325287] eth0: PHY ID 03625f24 at 30 IRQ POLL (stmmac-0:1e)
How to build OpenWRT image from github
72
Содержание BPI-R1
