Motor fixing
1. MOTOR FIXING WITHOUT PLATE
Prepare a platform in cement raised 40-50 mm from the floor and
perfectly straight.
Two plastic pipes for electrical wiring must emerge from the platform
in correspondance with the two holes under the motor.
Position the motor on the platform according to the measures in this
manual. Make four holes of at least 10 mm for the anchoring screws
and fix the motor in the cement platform.
2.MOTOR FIXING WITH PLATE
Tighten the four screws on the fixing plate. The screws must come
out on the top side of the plate about 50 mm to allow a fine regulation
of the motor.
Prepare a platform in cement raised 40-50 mm from the floor and
perfectly straight. Set the four screws with the plate in the platform.
Two plastic pipes for electrical wiring must emerge from the platform
in correspondance with the two holes in the plate.
Position the motor on the plate and use the bolts supplied to fix it.
Moving the bolt on the screw is possible to have a fine regulation of
the height of the motor.
FIXING OF THE METAL RAIL
Unlock the motor with the emergency release.
Lay the first meter of rail on the pinion of the motor and on the gate.
The fixing pins must be set in the middle of the rail holes. Check that
the rail is straight and weld the pins into the gate. Couple the second
meter of the rail with the one already welded, to make sure that the
distance is right, use another piece of rail for the coupling (see figure
5). Repeat these operations for the full length of the gate.
Move the gate manually verifyng that it slides smoothly, if necessary
fine tune the height of the rails. Is very important to leave a clearance
of 1-2 mm between the rail and the pinion of the motor.
When all the regulation are done, tighten the screw and grease the
rail slightly.
Fig. 5
11
Содержание ROY9
Страница 2: ......
