BALZER ELIMINATOR VACUUM TANK Series, Руководство пользователя

Страница: 49 / 58

45 Eliminator Vacuum Tank (Tandem) User Manual
6 . Press Boom Cal
3
BOOM
CAL
ENTER
= 150
ENTER
(this is the width of the plow/injector toolbar in inches)
7 . Press the Up Arrow
1
to check the remaining Booms . The value for the remaining booms should be 0 .
8 . Press Speed Cal
4
SPEED
CAL
ENTER
= 598
ENTER
(this is the value for the Sky Trak GPS)
9 . Press Meter Cal
5
METER
CAL
ENTER
= 50
ENTER
10 . Press Valve Cal
6
VALVE
CAL
ENTER
= 43
ENTER
11 . Press Rate 1 Cal
7
RATE 1
CAL
ENTER
= 2500 .0
ENTER
(be sure to remember the 0 following the decimal point)
12 . Press Rate 2 Cal
8
RATE 2
CAL
ENTER
= 3000 .0
ENTER
Rate 1 and Rate 2 can have any desired application flow rate, however, both need to have a flow rate entered to complete
setup . These rates can be changed through this console after the setup is completed .
Record your settings for Boom Width, Rate 1, and Rate 2 for future reference should the controller need to be reprogrammed .
Boom Width (in Inches) Rate 1 Rate 2
If the controller needs to be reprogrammed, press and hold
CE
while turning the power on then start with Step 2 above .
For additional information on the Raven SCS660 NVM Controller, see the manufacturer’s manual that came with the unit .
For additional information on the Sky Trak GPS, see the manufacturer’s manual that came with the unit .
For additional information on the Krohne Optiflux Flow Meter and Signal Converter, see the manufacturer’s manuals that came
with the unit .
Rite Rate Console Cable Preparation
The Console cable should come prepared for immediate use . If needing to prepare the Console Cable, use the following steps .
1 . Open wire loom and pull the Orange wire back towards the 16-pin plug until it is about halfway between the 16-pin plug
and where the Red and White wires exit the Console Cable .
Figure 63
Cut Points
Rite Rate Flow System Programming (Continued)
TROUBLESHOOTING