Balluff BTL6-U101-M****-A-S4 series, Руководство пользователя

Страница: 46 / 124

20 english
7.1 Accuracy
The specifications are typical values for the BTL6-U… at
24 V DC, and room temperature, with a nominal length of
500 mm in conjunction with the BTL-P-1013-4R,
BTL-P-1013-4S, BTL-P-1012-4R, or BTL-P-1014-2R
magnet.
The BTL is fully operational immediately, with full accuracy
after warm-up.
For special versions, other technical data may
apply.
Special versions are indicated by the suffix -SA
on the part label.
Resolution 5 µm
Repeat accuracy ≤ 30 µm
Sampling rate
(dependent on the nominal
length)
≤ 1 kHz
Non-linearity at ±50 µm
Temperature coefficient
1)
≤ 30 ppm/K
Max. detectable velocity 10 m/s
7.2 Ambient conditions
Ambient temperature –40°C…+85°C
Storage temperature −40°C…+100°C
Humidity < 90%, non-condensing
Shock rating
Continuous shock
per EN 60068-2-27
3)
100 g/6 ms
50 g/2 ms
Vibration
per EN 60068-2-6
3)
12 g, 10…2000 Hz
Degree of protection per
IEC 60529
IP67
(when attached)
7.3 Supply voltage (external)
Voltage, stabilized
4)
18…30 V DC
Ripple ≤ 0.5 V
PP
Current draw (at 24 V DC) ≤ 150 mA
Inrush current ≤ 3 A
Reverse polarity protection Up to 36 V
(supply to GND)
Overvoltage protection Up to 36 V
Dielectric strength
(GND to housing)
500 V DC
2)
7.4 IO-Link interface
Transfer protocol IO-Link 1.1
Transfer rate COM3 (230.4 kBaud)
Cycle time min. 1 ms
Master-device process data 0 bytes
Device-master process data 8 bytes
PD cycle on 1.0 master min. 4 ms
PD cycle on 1.1 master min. 1 ms
Output value Position in µm
Data format 32-bit signed
Error value 0×7FFFFFFC
7.5 Dimensions, weights
Rod diameter 10.2 mm
Nominal length 25…4572 mm
Weight (depends on length) Approx. 2 kg/m
Housing material Aluminum
Rod material Stainless steel
Rod wall thickness 2 mm
Housing mounting via threads M18×1.5 or 3/4"-16UNF
Tightening torque
≤ 100 Nm
1) Nominal length 500 mm, magnet in the middle of the measuring range
2) For : Use in enclosed spaces and up to a height of 2000 m above sea
level.
3)
Individual specifications as per Balluff factory standard, resonant
frequencies excluded
4)
For : The BTL must be externally connected via a limited-energy
circuit as defined in UL 61010-1, a low-power source as defined in
UL 60950-1, or a class 2 power supply as defined in UL 1310 or
UL 1585.
7
Technical data
BTL6-U101-M _ _ _ _ -A/B/Y/Z-S4
Magnetostrictive Linear Position Sensor – Rod Style