BTL6-A/G301-M_ _ _ _-A1-S115
Micropulse AT Transducer in round profile housing
9
english
6
Programming (cont.)
6.3
Programming Output 2
Activate Programming mode:
Programming input
La or Lb = "on" until LED comes on
(4 s < t < 8 s)
BTL is in Programming mode:
"Error message" on both outputs
(10.5 V).
Select Output 2:
1) Programming input Lb = "on" until
LED constant on (4 s < t < 8 s)
Output 2 selected, both outputs
provide the current position value.
a) Set zero
1) Place Magnet 2 at desired zero
point.
2) Programming input La = "on" until
LED stays on (4 s < t < 8 s)
Zero for Output 2 programmed:
➔
see also: Programming mode
b) Set span
1) Place Magnet 2 at desired end
point.
2) Programming input Lb = "on" until
LED stays on (4 s < t < 8 s)
Span for Output 2 programmed:
➔
see also: Programming mode
If the value of the zero point
is further from the zero
point marking than the end
point, the output slope is
automatically set to falling.
Zero = 100 % and
Span = 0 % of output value.
LED off
LED on
BTL6-A/G301... with 2 magnets in the stroke range
Flash time
Code
On : Off
LED
flashing
rapidly
Fig. 6-3: Programming Output 2
Operating mode
La = on
➔
Programming input La to 0 V
(output)
Lb = on
➔
Programming input Lb to 0 V
(output)
LED on
LED
flashing
slowly
LED on
LED on
LED
flashing
rapidly
LED
flashing
rapidly
0.05 s : 0.05 s
0.15 s : 0.15 s
La
/ Lb
La
Lb
4 s < t <8 s
4 s < t <8 s
4 s < t <8 s
4 s < t <8 s
Lb
0.05 s : 0.05 s
0.05 s : 0.05 s
Programming mode
Programming mode
Press
button
