BALLHOG Ascent Series, Руководство пользователя

Страница: 13 / 20

888.496.5137
b
all
h
og
g
oals.com
PAGE 13
STEP 8 -BACKBOARD ATTACHMENT
Experienced Installer Tip:
Pre-install the four (#24) gray nylon tubes into the ends of the (#4) upper and (#3) lower arms. Apply a small
amount of spray adhesive to the smooth side of eight (#8) ABS washers. Slide the (#8) ABS washers over the (#24) gray nylon tubes and
adhere them to both sides of the (#4) upper and (#3) lower arm tabs.
•
Adjust the height of the (#3) lower arm to its lowest point.
•
With at least four capable adults, raise the (#2) backboard into position while the fifth person attaches the (#2) backboard to the (#3)
lower arm using the hardware shown in Image 10. This is a pivot point. Do not over tighten these bolts.
•
Raise the top of the (#2) backboard up and into position and attach the (#4) upper arms using the hardware shown in Image 10.
This is a pivot point. Do not over tighten these bolts.
Image 10
15 9 8 24
8
8 9 19
15 9 8 24
8
8 9 19
2
4
3
UPPER
Y-(LOWER)
UPPER
Y-(LOWER)
#3
#2
Note:
View of backboard upper & lower arms from above. Upper and lower
arms attach to the inside of the backboard mounting tabs.