BALLHOG Ascent Series, Руководство пользователя

Страница: 11 / 20

888.496.5137
b
all
h
og
g
oals.com
PAGE 11
STEP 6 - POLE ASSEMBLY - UPPER JACK ATTACHMENT
•
Remove the plastic zip tie from the (#6) jack and insert the (#7) jack pin as shown in Image 8.
Experienced Installer Tip: Located in both ends of the (#7) jack pin is a small amount of grease. Evenly apply a little bit of the grease
to the rubber grommets located on both sides of the (#6) jack before inserting the (#7) jack pin. This will allow the pin to slide a little
smoother thru the grommets thus preventing the grommets from rolling out of place. Now is also a great time to insert the two (#11)
white nylon tubes into the (#3) lower arm allowing a small portion to extend out each side of the arm. It is also beneficial to apply a
small amount of spray adhesive to the smooth side of the four (#8) ABS washers and slide them over the two (#11) white nylon tubes
adhering them to the sides of the (#3) lower arm.
•
Attach the (#6) jack and (#7) jack pin to the lower arm using one (#17) bolt, one (#9) stainless steel washer, two (#8) ABS washers,
one (#10) stainless steel tube and one (#11) white nylon tube as shown in Image 8 below. Fully tighten both (#17) bolts as well as
both (#17) bolts from Step 3.
Image 8
DETAIL #4
TOP OF JACK
TO LOWER ARM
17
9
8
10
11
8
8
6
7
3
17
9
11
10
8
NOTE:
INSERT FIRST