Baldwin Boxall OmniCare, Руководство по установке

Страница: 69 / 102

OmniCare EVC System
Installation & Commissioning Manual
OmniCare issue 1
61
C O M M U N I C A T I O N S
2. When the LEDs on the Switch Panels start to flash release the
All button. If the Fault buzzer sounds press and release the
Fault Accept button.
3. The flashing Red LEDs indicate the current Offset value, and
the Yellow LEDs indicate the current Range setting.
4. The first button push will set the Offset (from 0-15) and the
second button push will set the Range (from 1-16).
5. The third button push will toggle between “Master” and
normal. The sequence then repeats (Offset - Range - Master
- etc).
6. When all the Switch Panels have been set as required reset
the Control Panel by and pressing and releasing the “Reset”
button.
4.6.3.1 Example 1 - Settings for a Master Control Panel
Regardless of size, the Master Control Panel must have a zone
switch for each Remote Unit.
1. Using JP1, 2 and 3, set the Top Switch Panel to have a Base
Address of “1”, the next switch panel down should be set for
a Base Address of “17” etc.
2. Set the Offset of each Switch Panel to “0” (top left Red LED).
3. Set the Range of each Switch Panel to “16” (bottom right
Yellow LED), except for the last panel which should be set to
the number of zones in use.
4. Set the Top Switch Panel to be the Master Panel (LEDs
flashing twice as fast as the other panels).
N
OTE
: The Switch Panel that is currently set to be the "Master" will flash
the LEDs twice as fast as the other panels.