Baldus Touch 50, Инструкция по эксплуатации, Страница: 17 / 28

– 17 –
3.2. Go 8.5 mm from the bottom left and bottom
right corners of the mounting cut-out to the re-
spective side and 11 mm upwards. In each case,
draw a point there for the centre of the third and
fourth holes (see illustration).
4. Cut out the mounting cut-out using the right tool for
the material and use a 6-mm drill suitable for the ma-
terial to drill the 4 marked holes. the holes are each
8.5 mm in diameter.
5. now attach the Baldus® touch with the 4 screws (size
m5) and 4 washers included.
Diameter = 22 mm
Diameter = 4.5 mm
15 15
15
22
Baldus® Bag t assembly:
Fig. 15: 5 holes for the Baldus® Bag t, dimensions in mm
1. from the centre of the Baldus® touch, go 180 mm
downwards and draw a point there. A hole for the
Bag t brass nozzle, to which the hose is connected,
will be bored there later.
2. now mark the holes for the 4 screws (size m3):
2.1 from the point for the nozzle outwards, go 15
mm to the left and 15 mm upwards and draw
the first point for the screws there.
2.2 now go from the point for the nozzle out 15 mm
to the right and 15 mm upwards and draw the
second point for the screws there.
2.3 now go from the point for the nozzle out 15 mm
to the right and 22 mm downwards and draw
the third point for the screws there.
2.4 now go from the point for the nozzle out 15 mm
to the left and 22 mm downwards and draw the
fourth point for the screws there.
3. then drill the holes: the hole for the Bag t nozzle is
22 mm in diameter. the four holes for the screws are
each 4.5 mm in diameter.
4. now attach the Bag t with the 4 screws (size m3) and
4 washers.
Connecting the Baldus® touch
to the Baldus® Bag t:
Adjust the hose included (LW8) to the required length
and attach as follows to the Bag T (LW9) nozzle: Use a
hot air blower to warm the hose so that it softens. When
it cools down, the hose contracts again, becoming hard
and absolutely gas tight. Also use a hot air blower to
help attach the other end of the hose to the mixed gas
outlet connector on the Baldus® touch (see illustration).
Fig. 16:
Bag t with LW9 nozzle
Fig. 17: Connecting the Bag t to the Baldus® touch
Mixed gas outlet
Connecting
hose
4 screws
of the Bag t