Baldor PG 6000 Скачать руководство пользователя страница 23

Appendix B
Special Information for California

Special Information for California B‐1

MN2418

Information in this Appendix applies only to products operated in the state of California. 

LIMITED WARRANTY ON EVAPORATIVE EMISSION CONTROL SYSTEMS

 - 

CALIFORNIA ONLY 

The California Air Resources Board (CARB) and Baldor Generators (herein ”Baldor”) are pleased to explain the Evaporative Emission
Control System (EECS) warranty on your model year 2006 and later generator. In California, new generators must be designed, built
and equipped to meet the State's stringent anti-smog standards. Baldor must warrant the EECS on your generator for the period of
time listed below provided there has been no abuse, neglect or improper maintenance of your generator. Your EECS may include parts
such as the carburetor, fuel-injection system, ignition system, catalytic converter, fuel tanks, fuel lines, fuel caps, valves, canisters,
filters, vapor hoses, camps, connectors, and other associated emission-related components. Where a warrantable condition exists,
Baldor will repair your generator at no cost to you including diagnosis, parts and labor for the time period set forth below. 

BALDOR EVAPORATIVE EMISSION CONTROL SYSTEM DEFECTS WARRANTY COVERAGE

This evaporative emission control system is warranted for a period of two (2) years, subject to the provisions set forth below.  If any
covered evaporative emission-related part on your equipment is defective, the part will be repaired or replaced by Baldor.

OWNER'S WARRANTY RESPONSIBILITIES

As the generator owner, you are responsible for performance of all the required maintenance listed in your owner's manual.  Baldor
recommends that you retain all receipts covering maintenance on your generator, but Baldor cannot deny EECS warranty claims solely
for the lack of receipts.  As the generator owner, you should however be aware that Baldor may deny you warranty coverage if your
generator or a part has failed due to abuse, neglect, or improper maintenance or unapproved modifications. You are responsible for
presenting your generator to an authorized Baldor service center as soon as the problem exists.  The warranty repairs should be
completed in a reasonable amount of time, not to exceed 30 days from the date of delivery to the authorized Baldor service center.
If you have a question regarding your warranty coverage, you should contact Baldor - Generator Technical Support at
1-479-646-471 1.

CONDITIONS AND RESTRICTIONS EVAPORATIVE EMISSIONS CONTROL SYSTEM WARRANTY COVERAGE

Baldor warrants to the ultimate purchaser and each subsequent purchaser that the generator is: (1) designed, built and equipped so
as to conform with all applicable CARB EECS regulations; (2) free from defects in materials and workmanship that cause the failure
of a warranted part to be identical in all material respects to that part as described in Baldor's application of certification to CARB; (3)
the warranty period begins on the date the generator is delivered to an ultimate purchaser or first placed into service. The warranty
period is two years.

Subject to certain conditions and exclusions as stated below, the warranty on EVAP emission-related parts is as follows: Any warranted
part that is not scheduled for replacement as required maintenance in the written instructions supplied, is warranted for the warranty
period. If the part fails during the period of warranty coverage, the part will be repaired or replaced by Baldor at an authorized Baldor
service center at no charge to the owner. Any such part repaired or replaced under warranty will be warranted for the remainder of the
EECS warranty period. Any warranted part that is scheduled only for regular inspection in the written instructions supplied is warranted
for the EECS warranty period. Any such part repaired or replaced under warranty will be warranted for the remaining EECS warranty
period.  Any warranted part that is scheduled for replacement as required maintenance in the written instructions supplied is warranted
for the period of time before the first scheduled replacement date for that part. If the part fails before the first schedule replacement,
the part will be repaired or replaced by Baldor. Any such part repaired or replaced under warranty will be warranted for the remainder
of the period prior to the first scheduled replacement point for the part. Notwithstanding the provisions herein, EECS warranty services
or repairs will be provided at designated service facilities to service the subject equipment. The generator owner will not be charged
for diagnostic labor that leads to the determination that an EECS warranted part is defective, if the work is performed at an authorized
Baldor service center. Baldor is liable for damages to other Baldor generator equipment components proximately caused by a failure
under warranty of any EECS warranted part. Throughout the EECS warranty period, Baldor will maintain a supply of EECS warranted
parts sufficient to meet the expected demands for such parts. Any replacement part may be used in the performance of any EECS
warranty maintenance or repairs and must be provided without charge to the owner. Such use will not reduce the warranty obligations
of Baldor. Add-on or modified parts that are not exempted by the California Air Resources Board may not be used. The use of any
non-exempted   add-on or modified parts by the ultimate purchaser will be grounds for disallowing warranty claims.  Baldor will not be
liable to warrant failures of warranted parts caused by the use of a non-exempted add-on or modified part. This limited warranty does
not cover any part which malfunctions, fails or is damaged due to failure to follow the maintenance and operating instructions provided
with the generator.

EVAPORATIVE EMISSIONS CONTROL SYSTEM WARRANTED PARTS

: The repair or replacement of any warranted part otherwise

eligible for warranty coverage may be excluded from such warranty coverage if Baldor demonstrates that the generator has been
abused, neglected, or improperly maintained, and that such abuse, neglect, or improper maintenance was the direct cause of the need
for repair or replacement of the part. That notwithstanding, any adjustment of a component that has a factory installed, and properly
operating, adjustment-limiting device is still eligible for warranty coverage.  Parts covered under the California Evaporative Emissions
Warranty are (1) low permeation fuel lines and fittings.

Содержание PG 6000



























Отзывы: