Baldan CRI-A, Инструкция по эксплуатации, Страница: 19 / 71

Instruction Manual
17 - CRI-A
01 - 01 - Place the concave thrust washer (2) on the shaft (1), followed by the washer (3), nut (4) and lock (5), securing it with the pres-
sure washer (6) and bolt (7).
02 - 02 - Then put the disc (7), bearing (8), another disc (7), separator spool (9) on the shaft (1) and so on successively, as shown
in figure 4.
03 - 03 - When the set is complete with all the discs, bearings, separator spools, put the convex thrust washer
(10), the other washer (3) and nut (4), tightening with the key until the entire set is firmly secured.
04 - 04 - Then wedge the set of discs and tighten the nut (4) through impacts. When maximum
tightness is almost obtained, adjust the lock (5) with the convex washer (10), al-
ways tightening the nut until it coincides with the hole, fixing it with the
pressure washer (6) and bolt (7).
Figure 04
1
2
5
4
6
7
8
9
9
9
8
7
6
4
5 3
3
10
7
7
7
7
7
7