8
SYSTEM CONFIGURATION
The PC is used to configure the system entities. The system configuration is then sent from
the PC to the master keypad which then sends the system configuration to the keypads via
RF communications.
The Master Keypad handles the communications management between the PC, Host, and
the Dispense Keypads. There are no operator menus associated with the Master Keypad.
The Master keypad provides the date and time stamp for all transactions within the system.
It is required that the date and time be set on the Master keypad for accurate tracking.
The Master keypad must also be configured for work order verification and dispense result
archiving. The default setting for both functions is performed at the PC.
Work order verification can be done by the PC or host (DMS) system. There is also an
optional setting to not verify work orders.
Dispense result archiving can be selected to be done at the PC. If the host protocol is used,
the PC can be selected to not archive or can also be used to archive in parallel.
Default Screen Display
The “Default” screen shows the system date, time, and soft-
ware version number for information purposes only.
The screen display alternates between the “Default” screen (above) and the “Enter Pin No.”
screen (below). The “Enter Pin No.” screen displays for four (4) seconds out of every five
(5) seconds.
The “Enter Pin No.” screen is used by the Supervisor to
access the system setup screens.
The Supervisor Pin Number is initially 0000 and must be
changed from the PC.
