BALCO KOG6789, Инструкция по эксплуатации

Страница: 14 / 60

14
After Sales Support
1300 663 907
Model Number
KOG6789
customercare@balcolifestyle.com.au
4
Quick Guide
Construct and Connect
1.
Place the Control Box, Extruder Tower and Heated Print Bed on a
clean, level work space. Carefully remove the cable tie that holds the
Extruder in place
2.
Insert the Heated Print Bed lengthways between the legs of the
Extruder Tower and align the bolt holes on each side. Using the Hex
Wrench, insert and tighten the two external bolts. Place printer on
its side, then insert and tighten the two internal bolts
3. Carefully cut the cable tie on the left side of the Heated Print Bed
Base. Then, on the left side, insert the long cable connector marked
‘A’ into the motor connector of the Extruder Tower marked ‘A’
4.
On the left side, insert the short cable connector marked ‘B’ into the
motor connector of the Extruder Tower marked ‘B’
5.
On the right side, insert the connector marked ‘C’ into the motor
connector of the Extruder Tower marked ‘C’
6.
On the left side, insert the connector marked ‘D’ into the connector of the Extruder Tower
marked ‘D’
7. Remove the outer plastic nut from the Filament Spool Holder, then insert the threaded end
into the large hole of the Filament Spool Holder Stand. Tighten the plastic nuts on each side
to secure
8.
Position the Filament Spool Holder Stand on top of the Extruder Tower, then insert the bolts
and tighten with the Hex Wrench
9.
Ensure the power switch is in the OFF position, then insert the Power Supply Cable into the
back of the Control Box. Insert the other end into a nearby mains power outlet. Turn on the
power outlet, then turn on the 3D Printer, using the switch on the back of the Control Box
1
2
.