BALCO KOG6789, Инструкция по эксплуатации

Страница: 20 / 60

20
After Sales Support
1300 663 907
Model Number
KOG6789
customercare@balcolifestyle.com.au
1.3 Good 3D Printing Practices
Please refer to these steps during every print to ensure the best quality.
Before Printing
1.
Ensure your GCODE file is correctly setup, filament diameter is set to to 1.75mm and correct
temperature settings for the material you are using (refer to table 3.1, page 27)
2.
Check all cables and connectors are connected
3. Check that Heated Print Bed is level and approximately 0.1mm from the nozzle
4. Check that Heated Print Bed is clean and dust free and nozzle does not have excess material
stuck to it
During Printing
1.
Closely monitor the first layer being printed – Most problems will occur in the first layer. If
problems occur, stop the 3D Printer at the power outlet
2. Do not leave the 3D Printer unattended while in operation
3. Keep hands clear while machine is operating
After Printing
1.
Wait for the Heated Print Bed and Extruder to cool down
2. Carefully remove 3D Object. Never use Scraper towards your body. Keep Scraper evenly flat
when scraping to avoid damage to the Heated Print Bed. Damaged Heated Print Bed will
affect adhesion for future prints
3.
Store 3D printer in a clean, dry environment
Introduction
.