Balanced Body is not responsible for any damage caused by
incorrect assembly.
BEFORE BEGINNING ASSEMBLY
These instructions include a parts list. Please use this list to make
sure you have all the parts necessary for installation. If you are
missing a part, please contact our customer service department
at 1-800-PILATES (1-800-745-2837).
Note: If you have ordered a Tower bracket kit for a Reformer with
casters, refer to Appendix II for additional instructions.
If you had your frame Pre-drilled by the factory remove ALL
hardware installed into the holes used for the tower bracket and
angle brackets. The hardware removed is no longer needed.
REQUIRED TOOLS (NOT INCLUDED)
»
Hammer
»
Power drill
»
Socket wrench with 7/16” and 1/2” sockets
PARTS FOR TOWER (INCLUDED)
ITEM
PART NO
QTY
Vertical Tower frame tubes with
eyebolts installed
TRP0105
2
Horizontal Tower tube with eyebolts
and corner connectors
TRP0100
1
Push-Through Bar for Slider assembly
707-287
1
Yellow trap springs
SPR9002
2
Blue trap springs
SPR9004
2
Roll down bar
710-010
1
Yellow long springs
SPR9006
2
Purple long springs
SPR9461
2
Single cotton loops (pair)
101-005
1
Safety strap for tower with carabiner
210-058
1
Push Through Bar Slider assembly
N/A
2
Push Through Bar Slider shoulder bolt
619-202
2
21mm x 1/2 inch wrench
ALL0060
1
PARTS FOR THE TOWER BRACKET KIT
(INCLUDED)
ITEM
PART NUMBER
QTY
Tower Bracket
722-001
1
L shaped corner brackets
622-001
4
5/32" Allen wench
GEN9282
1
3/16" Allen wrench
GEN9280
1
21/64" drill bit
TOL1059
1
1/4" drill bit
GEN5555
1
Riser Receivers*
REF0048 (left)
REF0049 (right)
2
Risers with pulleys installed*
950-184
2
Riser retention pins*
GEN9402
2
Black plastic lanyards for riser pins*
GEN9037
2
1/4"-20 x 2-1/4" Button Head Screws
GEN7314
6
1/4"-20 x 3" Eyebolts
GEN9232
4
1/4" Flat washers
GEN9305
18
1/4"-20 Nylock nuts
GEN9021
12
5/16"-18 x 1-3/4" Carriage bolts
210-512
4
Large (5/16"-18) Nylock nuts
GEN9013
4
No. 10 finish washers
210-050
4
*Not included if ordered for Reformer with casters.
How to Assemble Your Tower Bracket Retrofit Kit
IMPORTANT:
This is a relatively complex installation procedure. It involves drilling holes into the Reformer frame. Please read through these
instructions before proceeding. If you are uncomfortable undertaking any part of this procedure, it is highly recommended that
someone with a serviceable knowledge of equipment assembly and tools install the bracket.
Contact Us
1-800-PILATES | +1-916-388-2838
pilates.com | [email protected]
400-349 | 01.30.19
