13. Install the new pulley blocks with the pulleys as shown in
Figure G. Use the removed bolt and outer washer to install
the new blocks with pulleys.
Note: When properly installed the eye bolt facing the carriage
is higher than the eyebolt on the end of the block. Repeat on
the other side.
INSTALLING LOWER MOUNT PULLIES
14. Using the provided wood template and drill bit you will drill
into the wood cross member at the head end. Hold the wood
template on the outside of the wood piece, flush with the
bottom of the wood and up against the left leg. The hole in
the wood template will be in the upper right corner of the
template. See Figure H. Hold the template firmly and drill
through the cross member. Flip the wood template over and
hold it up against the right leg and flush with the bottom
of the cross member. The hole should be in the upper left
position shown in Figure H. Drill through the cross member
holding the template in this position. You can also tape the
template into place if hard to hold. You can also hold up the
template and use a pencil to mark the hole on the wood.
Then remove the template to drill the wood.
15. Install the two provided pulleys into the drilled holes in the
head end cross member using two flat washer, two hex nuts
and an acorn nut per pulley. See Figure I for the order of the
hardware. Repeat this process for the other pulley.
INSTALL ROPE AND LOOPS
16. Place the black loops with pulleys on the shoulder posts
Figure J.
17. Thread one end of the rope through both pulleys under the
carriage and pull the ends evenly toward the tower. Figure K.
18. Take one end of the rope and thread up through the lowest
pulley on the head end cross member. Continue threading
the rope up through the upper, inner pulley on the tower and
pull toward the carriage Figure L.
Figure J
Loop
Pulley
Figure H
Figure I
Figure K
Figure L
Figure G
19
