Balance KH 5509, Инструкция по эксплуатации

Страница: 20 / 29

16
B
Check to see if the batteries in the display
remote control unit are empty. A warning
symbol will appear on the display screen
before the batteries are completely emp-
ty. Th
is is also explained in chapter .
“Maintenance of the scales” . Replace the
batteries with two new AAA/Micro type
batteries.
11.3. The display screen is
not functioning properly
Th e scales contain sensitive electronic compo-
nents. Th erefore it is possible that the scales
will not function properly if there are radio
transmission devices in the immediate vicin-
ity. Th
is could include mobile phones, walkie-
talkies, CB devices, radio remote control units,
other remote control units and microwave de-
vices. If the display screen is not functioning
properly, you should remove this type of device
from the immediate vicinity of the scales. In
most cases it should suffi
ce to switch off the de-
vices while the scales are being used.
ô
Note:
Avoid static charge or discharge because
this could result in display errors or sudden
switching off of the scales.
11.4. Error messages appear
on the display screen
11.4.1. “0-Ld”
If this error message is displayed, then the
weight on the scales exceeds  kg. Th
e scales
are not intended for weight exceeding  kg.
|
Warning!
Do not place a load of more than  kilo-
grams on the scales! Otherwise the scales
could be damaged beyond repair!
11.4.2. “Err”
If this error message is displayed, then the
scales can not measure body fat, muscle mass
and body water percentages.
A
Measurement will not function properly
if you are wearing shoes or socks. Always
take your shoes and socks off before stand-
ing on the scales.
B
Make sure that you have both feet on the
sensors on the top of the scales.
If measurement is still not possible:
C
Step off the scales and wait until it auto-
matically shuts off . Subsequently turn the
scales on again and start the measure-
ment process again.
If measurement is still not possible:
D
You should always carry out measurements
with clean dry feet. In some rare cases
however your feet could be too dry for the
measurement functions to function prop-
erly. In order to exclude the possibility that
this is the cause of the error message: Mois-
ten your feet using a damp cloth. Subse-
quently carry out the measurement again.
11.4.3. “––––”
Th is error message indicates that the display re-
mote control unit can not establish a connection
to the scales. Possible causes for this could be:
A
Th e scales are turned off . Turn the scales
on by gently touching the top of the scales
with your foot.
B
Th e display remote control unit is too far
away from the scales. In this case, move
closer to the scales with the display re-
mote control unit.
IB KH5509-10 UK.indb EN16 IB KH5509-10 UK.indb EN16 09.01.2006 16:12:30 Uhr 09.01.2006 16:12:30 Uhr