BATTERY & ADAPTER INSTALLATION
Projection Clock:
Main Power Source: Plug in the 4.5V adapter into the adapter socket at the back casing
** Continuous backlight, projection & light bar only available when adapter is connected
Backup Power: Lift off the battery cover, install 3 pieces of AAA backup batteries according to the
polarity indicated, close the battery cover.
RADIO-CONTROLLED CLOCK
The unit will start synchronizing the clock after battery/adapter installation or reset. In normal mode,
press “SET/
“ in the battery compartment to enforce searching of radio-controlled clock signal. The
antenna icon will appear during synchronization, if the icon disappears afterwards, radio time signal is
not available at the moment. Try other locations later. Place the unit away from source of
interference such as mobile phones, appliances, TV etc.
Antenna icon with full signal strength
will appear on screen if the reception of radio-controlled
time is successful. The radio-controlled clock will have a daily synchronization at 02:05 everyday.
Each reception cycle is around 2.5 to 10 minutes.
INDOOR TEMPERATURE
Indoor temperature is located on the top line of the display. Press “C/F“ button to select temperature
unit C/ F.
COLOR LIGHT BAR / NIGHT LIGHT
The color light bar is designed as an intuitive way to know the alarm On/Off status at night. It also
serves as a nightlight.
Light bar slide switch selection:
OFF:
Turn off the light bar
ON:
Turn on the light bar continuously
ALARM:
Light bar turns on when one of the alarms is set for the next 24 hours
NOTE: Light bar can be activated continuously only when adapter is connected
