MINIMUM CLEARANCES
COC-E1
CO11-E1
Inches
mm
Inches
mm
Right
1
25
1
25
Left
1
25
2
50
Rear
1
25
1
25
3A.
SET-UP / MOUNTING FOR COC-E1
1.
COC-E1: DIRECT PLACEMENT ON COUNTER
Counter-top installation must conform to one of the following methods:
a.
Make sure the counter is level.
b.
Clean the area where unit is to be installed.
c.
Place the unit in position on the counter and mark the outline of the unit.
d.
Remove the unit and apply 1 ¼ bead of sealer (
directly onto the counter following the
traced outline (see Sketch A).
e.
Place the unit in position, over the sealer, on the counter.
f.
With the unit in place, apply an additional heavy bead of sealer along all edges
(see Sketch B).
G.
Wipe clean any excess sealer.
Dow Corning RTV 732
Multipurpose Sealant or its equivalent)
3
Traced Outline
1 1/4” Bead of
sealer applied
onto counter
SKETCH “A” - TOP VIEW
BAKERS PRIDE
Bead of sealer
along oven edges
SKETCH “B” - FRONT VIEW
2.
COC-E1: INSTALLATION / MOUNTING 6” LEGS (Optional)
3B
SET-UP / MOUNTING FOR CO11-E
1.
CO11-E1: INSTALLATION / MOUNTING 30” LEGS
a.
The adjustable legs are not shipped mounted to unit. The legs are packed inside the
unit with the wire shelves.
b.
After unpacking the unit, remove legs and any other material from inside the oven.
c.
Place the unit on a counter or other flat, stable surface.
d.
With sufficient help, tilt the unit back far enough to mount the two front legs.
e.
Tighten the upper part of the leg with an adjustable wrench.
f.
After installing the front legs, lift the rear of the unit more than 6 off the surface and
block in position using wood or some other solid material.
g.
Mount the two rear legs and tighten them in the same fashion.
h.
Using proper equipment, move the unit to its final location.
i.
To ensure proper operation, the unit must be level. Each leg can be adjusted
separately to achieve proper leveling.
J.
Install the shelf supports and the wire shelves.
a.
After unpacking the unit, remove legs and any other material from inside the oven.
b.
Tilt the oven onto its left side and attach the two right legs using three ½ bolts and
washers for each leg. Tighten firmly.
Note: Units must be leveled after leg installation. Each leg is individually adjustable.
