Baker Hughes Masoneilan SVIII AP, Руководство по установке и обслуживанию, Страница: 195 / 204

Masoneilan SVI II AP Installation and Maintenance Manual =
|
195
© 2017 Baker Hughes, a GE company, LLC. All rights reserved.
3 4 FactoryModeFault Mode allowed only for
flashing firmware upgrade. 1. Remove power to the device
for two minutes and restart the
device.
2. Clear the alarm using ValVue
or HART® Host.
3. If the failure persists, replace
the complete device or electron-
ics module.
3 5 NVMTestError Failure Hardware failure. 1. Remove power to the device
for two minutes and restart the
device.
2. Clear the alarm using ValVue
or HART® Host.
3. If the failure persists, replace
the complete device or electron-
ics module.
4 0 RefVoltageFault Failure Hardware failure. 1. Remove power to the device
for two minutes and restart the
device.
2. Clear the alarm using ValVue
or HART® Host.
3. If the failure persists, replace
the complete device or electron-
ics module.
4 1 PositionSensor-
Fault Failure Positioner sensor not read-
ing proper values
.
1. Use Smart Assistant to con-
firm selection of proper travel
sensor.
2. Ensure that the mounting kit
magnets are moving only +/-65
degrees (sensor should read
between -10k to 10k counts w/
no jumps i.e. while traveling in
one direction reading -8000
counts, -9900 counts then read-
ing +10,000 counts).
3. If using remote verify that it is
powered and wiper is con-
nected, verify wiper voltage
between 0 and 1.25 V.
4. If correct sensor selected,
replace electronics module and
report the problem at svisup-
port@bhge.com.
Table 30 Device Status Diagnostics (Continued)