Baker Hughes Druck DPI 610A, Инструкция по эксплуатации

Страница: 7 / 20

Copyright 1998 Baker Hughes Company.
English–DPI610A Instruction Manual | 5
1.1 Pneumatic Controls
An AN4 connector provides the output connection. The instrument is designed to operate with
5 meters of 6 mm bore pipe attached.
Figure 2: DPI 610A Pneumatic Controls
1.2 Electrical Connections
Refer to publication K0415 for the fitting of batteries and the charging of batteries.
1.3 Maximum Instrument Ratings
The following table shows the maximum measurement ratings of the standard instrument that
should not be exceeded. Pressure over range (120% of FS) is indicated by a flashing pressure
display. Voltage or current over range (110% of max) causes either the voltage or current display
to flash.
Note:
When the AERO task is selected, the display flashes if the voltage or current input over
ranges by 110% of the above maximum values. The pressure display flashes at altitudes below
- 3000 ft and above 50,000 ft or at airspeeds greater than 600 knots, depending on the mode
selected.
Parameter Maximum Rating
Pressure 120% of full-scale
Voltage 50 V DC
Current 55 mA DC
OPEN
CLOSE
OPEN
CLOSED