Bake Max TCO6G, Инструкция по установке и эксплуатации, Страница: 28 / 92

Stage 3B - Washing
After the Washing Preparation phase, the cycle will start the Washing phase.
The washing phase takes 10 minutes during which the Combi oven TOUCH is brought to the
washing temperature of 70 °C, the ventilation is always active at maximum speed, the recirculation
system pump that will supply hot water to the chamber from the condenser is activated, by passing
it to the detergent tablets.
No steam is to be introduced at this stage.
A 2-minute time is then loaded during which the Combi oven TOUCH disables all uses (except light)
to allow detergent action.
The Duty Cycle (detergent action time) will be repeated:
- 3 times in case you are running a SOFT washing cycle;
- 6 times in case you are running a MEDIUM washing cycle;
- 9 times in case you are running a HARD washing cycle;
During the entire washing phase, if enabled via parameter P3 and if the value of the Water Drain
probe is higher than the maximum water flow set point 70 °C, the controller will activate the Network
Water Supply output to reduce the temperature of the condenser.
The differential of this setting is fixed at -10 °C, i.e., the water supply is interrupted when the
temperature read by the probe Water Drain is below 10 °C in relation to the maximum set point of
water drain 70 °C.
At the end of the number of cycles foreseen for the current one, the next phase will be initiated.
Phase 4B - Rinse
This phase lasts 12 minutes during which, the water supply from the condenser´s water network,
the direct injection of steam and ventilation at full speed, will be activated.
No heating phase is foreseen and no recirculation system is provided. Once the rinsing time has
elapsed, the cycle will pass to the next stage.
Stage 5B - Drying
After the rinsing phase, the drying stage starts.