Bakcou Kodiak AWD, Сборка

Страница: 3 / 7

BAKCOU.COM
HANDLEBAR ASSEMBLY
9. Using 4mm Allen wrench, remove 4 screws from handlebar stem.
10. After removing the front plate of the handlebar stem, insert center of
handlebars into handlebar stem, then reattach the front plate and 4
screws to secure handlebars.
11. Make certain handlebars are positioned with the throttle to the left
and the rapid-fire index shifting levers on the right. Slightly insert
each of the 4 screws prior to tightening. Also prior to tightening,
rotate handlebars forward or backwards to customize position of
handlebars to rider. NOTE: In most cases, brake levers should be
angled approximately 45 degrees downward for optimal positioning.
12. Display screen can be easily adjusted by loosening with a 3mm Allen
wrench and rotating to desired position. To adjust the display, you
will need to loosen the screws on each side of the display.
3.
For further assistance, go online for helpful instructional videos at bakcou.com
PUTTING ON FRONT TIRE
13. If present, remove plastic spacer from bottom of front fork.
14. If present, remove the plastic insert from between front brake pads.
DO NOT squeeze the brake levers after removing this plastic
insert before installing the tire. Doing so will cause the brake pads
& pistons to overextend, and therefore will not retract to original
position.
15. Position the front wheel in the front fork and the front brake rotor
between the brake pads. Find the tooth on the inside of the washer
on the front wheel axle and align with the slot on the fork. The wheel
will not fit if this is not aligned correctly.
16. Wrap the motor connection cord to the top & plug in.
17. Tighten the nuts with a 19mm wrench or socket.