bajaj electricals limited Page 5 of 5
The Do's and Don'ts
1.
Read installation and operating instructions carefully before use.
2.
Get an authorised plumber to install the geyser.
3.
Allow the water to flow out from the outlet. Only then, switch ON the power supply.
4.
After use, make sure that power supply is switched OFF before closing the inlet (non-pressure type) or outlet
(pressure type)
5.
Please ensure that proper earthing is provided to the unit.
6.
Please contact the nearest bajaj Sales or Service Centre in case of any problem/non-operation of the unit.
7.
The working of Thermostat in MK-II & MK-VI ISI should be checked once in a while by ensuring that the
green light glows ON & OFF when the unit is in use. The working of Thermal cut-out in MK-V ISI should be
checked in the same manner.
8.
Always get the unit serviced at least once in two years. Use genuine spare parts when replacement is
necessary.
Don'ts
9.
Do not provide a non-return valve at the outlet in case of Pressure type installation.
10.
When the red light glows ON in MK-VI ISI model do not operate by resetting the thermal cut-out. Instead
contact the nearest Bajaj Sales & Service Station to test/replace the thermostat.
11.
In case the fusible plug has operated and water flows from the drain, contact the nearest Bajaj Sales &
Service Station.
12.
Under no circumstances the setting of the Thermostat or Thermal cut-out should be increased
beyond the preset temperature.
13.
Safety valve, Thermostat, Thermal cut-out are preset and sensitive devices. Any
tampering/resetting them could damage the unit & even prove dangerous. This should be strictly
avoided.
