INSTALLATION
SETUP/PHYSICAL INSTALLATION
2 - 6
I-E96-406A
®
To install the cables follow these steps.
1. Pull the master modules several inches from the MMU
backplane.
2. Insert the J2 end of the NKTU01 or NKTU11 termination
unit cable into the MMU backplane slot assigned to the pri-
mary master module. The cable should latch securely in place.
Card edge connector P3 of the master module connects to this
end of the cable.
3. Insert the J1 end of the NKTU01 or NKTU11 cable into P2
on the NTAM01 unit. The cable should latch securely in place.
4. If the IMAMM03 module is nonredundant, go to Step 7.
5. Insert the J2 end of the NKTU01 or NKTU11 cable into the
MMU backplane slot assigned to the redundant master mod-
ule, if one is installed. The cable should latch securely in place.
Card edge connector P3 of the master module connects to this
end of the cable.
6. Insert the J1 end of the NKTU01 or NKTU11 cable into P3
on the NTAM01 unit. The cable should latch securely in place.
7. Insert the J1 end of the NKAI01 or NKAI11 cable into P1 on
the NTAM01 unit. The cable should latch securely in place.
8. Connect the J2 end of the NKAI01 or NKAI11 cable into P4
on the first NTAI02 unit (this is the cold junction compensation
pair A termination unit) interconnected with the NTAM01 unit.
Up to four NTAI02 units can be interconnected with NKAI01 or
NKAI11 cables.
9. If a single NDIS01 station is required, connect P4 of the
NTAM01 unit to P1 of the NDIS01 station with an NKDS01 or
NKDS11 cable. Connect the J1 end of the NKDS01 or NKDS11
cable to P4 of the termination unit and the J2 end of the
NKDS01 or NKDS11 cable to the left slot on the station hous-
ing (P1 of the NDIS01 station).
10. If multiple NDIS01 stations are required, connect P4 of the
NTAM01 unit to P1 of the first interconnected NDIS01 station
CAUTION
Remove modules from their module mounting unit slots before
installing or removing a cable assigned to that slot. Failure to
do so could result in damage to the module.
ATTENTION
Retirer le module de son emplacement dans le chassis de
montage des modules avant d'installer ou de retirer un câble
assigne a cet emplacement. Un manquement à cette procédure
pourrait endommager le module.
