Baileigh TS-1040E 30, Руководство оператора

Страница: 38 / 52

35
35
Lubrication
The table saw has sealed lubricated bearings in the motor housing and the arbor assembly, they
will not require any additional lubrication. Use a wire brush to clean off the worm gears and
trunnions and apply a white lithium grease to keep them lubricated.
Changing Belts
1. MAKE SURE THE POWER CORD IS
DISCONNECTED FROM THE POWER SOURCE!
2. Lower the blade completely, and then open the motor
access cover.
3. Loosen the hex nuts that secure the motor (A, Fig.
34) and raise the motor fully to remove tension on the
V-belts.
4. Roll the V-belts off of the arbor and motor pulleys.
5. While continuing to raise the motor, install a new
matching set of V-belts onto the pulleys, lower the
motor to tension the V-belts, then tighten the hex nuts.
6. Check V-belt tension (Fig. 35).
7. Close the motor access cover.
Fig. 34
Fig. 35