Baileigh STS-16120CNC, Руководство оператора

Страница: 48 / 56

46
46
Touch Screen Troubleshooting
NO. TROUBLE ACTION
1 Error dimension statistics Input correct numerical value
2 Rip fence paused
Safety bar is touched.Please release it and
push START key again.
3 Rip fence moved into safety area
Push START key until rip fence reaches the
position of the input value.
4
Rip fence do not load on the working
table
Turn the rip fence over to the working table.
5
Main saw blade rise protective switch
ON Check if the main saw blade rise limit value
setting and the sensor's position are correct.
6
Main saw blade down protective switch
ON Check if the main saw blade rise limit value
setting and the sensor's position are correct.
7
Main saw blade titlt increase protective
switch ON
Check if main saw blade tilt increase (+) limit
value setting and the limit switch's position are
correct.
8
Main saw blade titlt decrease protective
switch ON
Check if main saw blade tilt decrease (-) limit
value setting and the limit switch's position are
correct.
9
Fence vertical movement protective
switch ON
Check if fence (aluminum fence is vertically
put)(+) limit value setting and the limit switch's
position are correct.
10
Fence horizontal movement protective
switch ON
Check if fence (aluminum fence is horizontally
put)(-) limit value setting and the limit switch's
position are correct.
11
Rip fence move increase protective
switch ON
Check if fence (aluminum fence is horizontally
put)(+) limit value setting and the limit switch's
position are correct.
12
External safety switch or EMG stop did
not switch to the correct place Turn EMG switch to OFF. Release EMG
switch.
13
Main saw blade did not move after
START Check if the encoder's wiring is correct and
the relay runs normally.
14
Main saw blade did not elevator to the
target position
Check if the input value exceeds the limit
position, the limit parameter is correct and the
saw blade's size is correct.
15 Main saw blade did not tilt after START Act as No. 13.
16
Main saw blade did not tilt to the target
position
Act as No. 14.