Baileigh RTS-3012, Руководство оператора

Страница: 21 / 28

19
19
SLIDING TABLE
1. Use the toggle clamp to fix the workpiece to the
sliding table.
2. The push plate position can be set by loosening
the push plate lock knobs, adjusting the position,
then retightening the knobs.
3. The sliding table can be made stationary by setting
the lock tabs on the ends of the sliding table.
TILTING THE PUSH PLATE TO 45°
1. Loosen and take out the inside lock knob on the
push plate.
2. Tilt the push plate until the predrilled hole on the
push plate is aligned with the middle T-slot on the
sliding table.
3. Replace the inside lock knob to lock the push plate
at a 45° angle. The push plate is now angled for
bevelled routing.