Baileigh RDB-480, Руководство оператора

Страница: 33 / 60

30
30
Material Insertion
Note: The photos and illustrations used in this manual are representative and may
not depict the actual color, labeling or accessories and may be intended to illustrate technique
only.
1.
At the start page, choose “RUN PROGRAM” and choose program to run following screen
instructions.
2. Once the die set is properly installed and the desired program is loaded and performs as
needed, the correct size material can now be inserted.
3.
With the die head at home or “0” position, insert material past the hook arm aligning the “0”
mark on the die with where the bend will start on the material.
Important: Liberally apply lubricant along the counterdie and the 1/2 of the
material that contacts the counter die with a WD-40 style lubricant or equivalent. Do not
lubricate the bending die. Lubricating the bending die will encourage slipping of material in the
bending die.
4. Tighten the counter die assembly applying moderate pressure on the material.
5. With the counter die tight, document the number displayed on the Leadscrew counter, you
will want to return to the same exact number every time to ensure exact counter die
positioning and repeatable bends. This number can be entered in the control for
programmed bends.
6. Be sure there are no obstructions along the draw side of the material.
7. Be sure to leave enough material past the plastic slide to produce the desired bend.
Spray lube
here
Draw side
of tubing
Hook Side
of Tubing