Baileigh IP-2011-HD, Руководство оператора

Страница: 32 / 48

29
29
ANTI-KICKBACK FINGERS
This planer provides an anti-kickback system as a safety feature. The anti-kickback fingers hang
from a rod suspended across the cutterhead casting. The anti-kickback fingers should be
inspected regularly.
Check the anti-kickback fingers to ensure that they swing freely and easily. If the fingers resist
easy movement, clean them with a wood resin solvent.
Do not apply oil or other lubricants to the anti-kickback fingers. Oil or grease will attract dust,
restricting the free movement of the fingers.
INFEED ROLLER TENSION
The amount of tension or downward pressure of the infeed roller needs to be enough to push
the workpiece into the cutterhead but not enough to gouge or bind the workpiece. Tension
requirements will be different for rough lumber and milled lumber.
1. UNPLUG OR DISCONNECT PLANER FROM POWER SOURCE AND LOCK OUT POWER.
2. Remove the top right and left access panels and
identify the infeed roller tension springs (Figure 16).
3. Adjust the infeed roller tension with the hex nut
underneath the tension spring (Figure 16).
Note : To reduce the tension, lengthen the
spring. Conversely, to increase the tension, shorten the
spring.
4. Replace both access panels.
CAUTION:
Proper operation of the anti-kickback fingers is essential for
the safe operation of this machine. Failure to ensure that they are working properly
could result in serious operator injury.
Fig. 16