17
B - High / Low Gear Selector - A gear transmission lever that
selects Hi or Low speeds.
IMPORTANT: Use only while the machine is
stopped. Failure to do so will cause damage to the gear
system.
Drill Head
The Drill Head attaches to the top of the column. It houses the motor,
spindle, controls, and transfer mechanisms. Attached to it is the electrical
enclosure, the protective guard, the work light, and the coolant valve with
nozzle.
Work Table
The sturdy work table can be positioned at varying heights and
rotated 180° in either direction. It has T-slots to allow the use of 1/2”
or M14 bolts. Below the work table are three crankshafts. The two
crankshafts (H) control the up /down motion of the table. Always
unlock the table with crankshaft (K) before changing the height or
rotating it. Then lock the work table to secure in position. The one
handle works for all three crankshafts.
Machine Base
The machine base houses the coolant reservoir and supports the
coolant pump (I). The coolant is pumped up to a nozzle where a valve
controls the flow onto the tool. The coolant / lubricant enters the table
drain and flows back to the reservoir.
B
H
H
K
I
Содержание DP-1250VS-HS
