Baileigh Industrial IP-1306, Руководство оператора

Страница: 35 / 48

32
32
Gear Lubrication
The gears in the gear box should be lubricated periodically.
1. Facing the front of the machine, remove the raise/ lower
handle.
2. Remove the 9 screws holding the top cover on the
machine. 5 screws are located on top and 4 on the
upper sides. Remove the top cover.
3. On the left side panel, remove the 4 socket head screws
located around the bottom edge and remove the side
panel to expose the gearbox cover.
4. Remove the two screws (C) to remove the gear box
cover (B) and access the gear box.
5. Replace all covers, panels, and guards that you
removed once lubrication is complete.
Brush Replacement
Brush life will vary depending on the load placed on the
motor. The brushes should be inspected every 20-30
hours of motor run time.
To inspect or replace:
1. Remove the brush holders, one of which is shown at
(A). The other is located in the same position on the
rear of the motor assembly. The Brush Holder can be
removed using a flat blade screwdriver.
2. Once the brush has been removed, inspect the carbon
(B), the spring (C), and the wire (D).
•
If the carbon of either brush is worn down to 3/16” or
less, both brushes should be replaced.
•
Also, if the spring or wire are burned or damaged in
any way, both brushes should be replaced.