Baileigh Industrial DP-2012F-HD-V3, Руководство оператора

Страница: 18 / 40

16
16
11. Slide the column ring (19) onto the column with the inside bevel in the down position as
shown.
12. Adjust the ring until the tip of the rack fits inside the bevel. The rack should now be captured
in the bevel groove at the bottom and top.
13. Tighten the setscrew (21) on the ring.
14. Install the table (15) onto the support bracket and secure in position with the locking handle
(13).
15. Loosen the table support arm clamping lock handle (16) and swing the table to the left 70° -
90° and tighten the clamping lock handle.
Headstock
16. Using a lifting device or an assistant, lift the head
assembly over the column and insert the column
into the pocket on the bottom of the head assembly
until the column is fully seated into the head pocket,
approximately 4
” (100mm).
17. Position the headstock directly over the base by
using a plumb bob and measuring tape or ruler
across the drill press base to find its center.
18. Suspend the plumb line from the center of the
headstock label and lower the bob until it is near the
tape/ruler as shown.