Baileigh Industrial DP-0625E, Руководство оператора

Страница: 25 / 36

23
23
Drill Protection Guard
The machine is provided with a security drill guard.
Before pressing the starting push button, set the drill
guard in the working position, otherwise the machine
controls will not start.
Important: If the guard is opened when
operating the machine, the machine will stop. DO NOT
REMOVE THE GUARD UNDER ANY
CIRCUMSTANCES.
The drill guard can be adjusted for height and position.
1. Loosen the two thumb knobs (A) to increase or
decrease the height of the drill guard.
2. Slide the lower half of the guard up or down within
the slots to set the height.
3. Tighten the thumb knobs to hold the lower guard in
position.
4. The drill guard can slide up within the mounting
bracket with the stop block (B) stopping the
downward travel. (Drill guard shown fully lowered.)
5. The stop block (B) can be set at different positions by loosening the lock bolt (B also), sliding
the guard and shaft assembly upward, and then tightening the lock bolt to hold the guard at
that position.
A
B