Baileigh Industrial DP-0625E, Руководство оператора

Страница: 15 / 36

13
13
•
WORKING CLEARANCES: Take into consideration the size of the material to be
processed. Make sure that you allow enough space for you to operate the machine freely.
•
POWER SUPPLY PLACEMENT: The power supply should be located close enough to the
machine so that the power cord is not in an area where it would cause a tripping hazard. Be
sure to observe all electrical codes if installing new circuits and/or outlets.
Anchoring the Machine
•
It is recommended to allow a minimum of 30”
(762mm) on each side of the machine to allow for
head and or table swing.
•
This machine requires a solid floor such as concrete
at a minimum of 4” (102mm) thick. 6” (153mm)
minimum is preferred.
•
Once positioned, anchor the machine to the floor, as
shown in the diagram. Use bolts and expansion
plugs or sunken tie rods that connect through and
are sized for the holes in the base of the stand.
WARNING:
Before operating the Baileigh Drill Press make sure it is
firmly bolted to the floor. If it tips over on you, it could cause severe injury or death.
.31"
(7.87mm)
.50"
(12.7mm)