Baileigh Industrial BS-350SA, Руководство оператора

Страница: 24 / 60

21
21
Quick Clamp Vise
Place the piece part between the vise jaws and have it rest
next to the fixed vise jaw.
Rotate the hand wheel (A) clockwise (cw) to close the front
jaw onto the piece and tighten.
Rotate the hand wheel counterclockwise (ccw) to release.
For multiple cuts of a same size material, leave a
.5” – .75”
(13
– 19mm) gap between the piece part and the vise jaw.
Push cycle start switch.
The vise will automatically clamp the piece part while going
through the operation cycle.
When the cycle is finished, the vise will open, and the piece
part can be adjusted or removed.
Note: The hydraulic unit must be running.
Footpad Switch
Using the side of your foot, push aside the plastic clip that
blocks the footpad of footswitch (T).
Be careful not to damage the clip by using excessive force or
stomping on the footpad.
Now step down on the footpad to start the saw operation.
Setting Cut Length
Setting the cut length eliminates measuring duplicate pieces.
•
Measure and mark the length of material to be cut off.
•
Loosen the stop bar clamp handle (AH) and slide so that
the tip of the stop bar touches the end of the piece part.
•
Tighten the stop bar clamp handle.
•
Proceed with the cutting cycle
•
After the piece is cut and the vise opens, Slide the piece
part forward until it reaches the tip of the stop bar.
•
Proceed with the cutting cycle.
figure 9
T
figure 8
figure 7
B
A
AH