Baileigh Industrial BS-330SA, Руководство оператора

Страница: 42 / 76

39
39
Adjusting Vise Square to the Blade
1. Disconnect the machine from the power source.
2. Place a machinist's square on the table against the blade and the vise (fixed). The Square
should lie along the entire length of the vise and blade without any gaps.
3. If adjustment is necessary, loosen bolts holding the vise and adjust vise so that the square
lines up properly. Tighten bolts.
4. Connect machine to the power source.
Vise and Angle Cutting Adjustment
To position the saw arm to cut at 45° angle.
1. Disconnect the machine from the power source.
2. Push the handle (E) towards the hand wheel and
push the short handle (not shown) beneath the
gearbox, towards the motor end of the saw to
release the upper assembly.
3. Rotate the upper assembly using both hands as
shown to the desired angle by following the index on
the scale (F).
4. Pull the handle (E) towards the motor end of the saw
and the short handle towards the hand wheel to lock
the upper assembly.
5. Properly load the work piece and start operation.
E
F