Baileigh Industrial BS-330SA, Руководство оператора

Страница: 39 / 76

36
36
SET UP AND ADJUSTMENTS
Work Stop-Bar Adjustment
The stop bar can be adjusted during angle cutting, and the procedure is as follows:
1. Unfasten the handle (A) and use a hex wrench (hex
key wrench) to loosen the hex socket set screw (B).
2. Push the bar gradually to the right side to get the
desired angle and then tighten the set screw (B) and
handle (A).
Note: There are four presets. They are at
0°, 15°, 30°, and 45° angles.
3. Loosen the handle (C), and according to the scale
(D) adjust the length by moving the stop bracket (E).
4. Retighten the handle (C).
Guide Post Positioning
The blade guides should be set as close to the vise
jaws as possible. The right blade guide bracket (A)
has limited adjustment to clear the right hand vise jaw.
The left blade guide bracket (B) can be moved to the
left or right depending on the size of the workpiece.
1. To move the left blade guide bracket (B), loosen
the hand knob, position blade guide bracket as
close to the work piece without interfering with the
material, blade, or vise.
2. Tighten the hand knob.
B
A
B