Baileigh Industrial BR-16E-36, Руководство оператора

Страница: 16 / 36

14
14
Note:
Most beading operations will need to be done in several steps, increasing
the depth on each pass. Trying to bead too deep will flex the machine, so take your time with
multiple passes.
• Do not start with the rolls completely closed as you may find that the rolls are too close
together and find it difficult to feed the material.
7. Place the Forward/Reverse switch in the desired position based upon direction of feed.
Forward will feed material from right to left. Reverse will feed material from left to right.
8. Step down on the foot pedal while feeding the work-piece through the die set. Check the
work-piece. It may be necessary to fine tune the adjustment to the depth of the bead to
reach the desired bead depth.
9. When doing beads, you can feed the panel from one end to the other, increase pressure,
and switch the machine to reverse, to back it up
10. When the material has been fed through the rolls for one pass, release the foot pedal and
then, either remove the material if the bead is complete, or toggle the switch to the opposite
directions and feed the material back in the opposite direction increasing the pressure on the
rolls.
11. This may be repeated until the desired bead is achieved.
MATERIAL SELECTION
When selecting materials keep these instructions in mind:
•
Material must be clean and dry. (without oil)
•
Material should have a smooth surface so it processes easily.
•
Dimensional properties of material must be consistent and not exceed the machine capacity
values.
• Chemical structure of material must be consistent.
•
Buy certificated steel from the same vendor when possible.
CAUTION:
It must be determined by the customer that materials being
processed through the machine are NOT potentially hazardous to operator or
personnel working nearby.