Baier Elektrowerkzeuge BSM 160, Перевод оригинального руководства пользователя

Страница: 24 / 64

| 24 |
EN
3.2 Declaration of Conformity
We herewith declare, with sole responsibility,
that this product conforms to the following
standards or normative documents:
EN 62841-1:2015 + AC:15
EN 62841-2-10:2017
EN 55014-1:2017
EN 55014-2:2015
EN IEC 61000-3-2:2019
EN 61000-3-3:2013 + A1:2019
in accordance with the provisions of the Directives
2014/30/EU; 2004/108/EC
The head of development is authorised to write the
technical documents.
These are available from:
Maschinenfabrik OTTO BAIER GmbH,
Heckenwiesen 26,
71679 Asperg
Germany
Thomas Schwab
Managing Director
Robert Pichl
Factory Manager
Asperg, 21.04.2021
3.3 Machine characteristics
The lock button for continuous operation is
equipped with a safety function. If the power supply
is interrupted during continuous operation, the
machine does not restart immediately after the
power is restored. The machine does not restart
until the switch is pressed again.
3.4 Machine parts and controls
(see Figure 1 / 2 )
1 ON / OFF switch
2 ON / OFF switch locking device
3 Gear selection switch
4 Speed control
5 Stirrer holder M14
6 Handles
7 Connection cable
3.5 Intended use
BAIER high-speed mixers are suitable for stirring
paints, plasters, mortars, adhesives and similar
materials. They may not be used to stir food, highly
flammable or caustic substances.
4 Before Starting Work
To ensure safe working with the high-speed mixers,
the following points must be observed before each
use:
•
Read through all safety instructions and
warnings in this instruction manual.
•
Wear protective clothing such as hard hat, face
protection or safety goggles, safety gloves and if
necessary an apron.
•
The voltage on the rating plate must be identical
with the mains voltage.
•
Before using the machine, always check the
connection cable and plug.
•
Do not use reducers or adaptors to when fitting
the spiral stirrer.
DANGER
Risk of poisoning due to toxic gases.
Risk of burns and fire due to flammable gases.
Î
Do not process liquids or materials with
unknown hazard potential.
Î
Observe the instructions for use issued by the
manufacturer of the material to be stirred.
Î
When processing plastics, paints, varnishes
and similar materials, do not work near
flammable gases or materials.
NOTE
Changing gear while the machine is running can
cause damage to the drill.
Wait for the machine to completely stop.