11
www.stairslight.com
Installation diagram: 12V motion sensors connected to the controller
The diagram below shows exactly how the whole set is built with the use of 12V motion sensors.
Before mounting the sensors, please set their time of action and sensitivity to a minimum. In the
case of sensors with a jumper used to select the operating mode with or without triggering, choose
the position “non-repeatable trigger.”
These two sets of adapters with sensors should be mounted in their appropriate place by the
side of the first and the last step.
The controller can handle additional input located on the mezzanine. In such a case, an additional
motion sensor (or an additional push button) should be placed so as to detect the entrance a person
to the staircase mezzanine, but so it does not react to people walking up the stairs.
After detecting a person entering the stairs to the mezzanine, the controller will immediately
start the lighting of the whole staircase and turn it off after approx. 20 seconds. The diagram on the
neighboring side shows such a solution.
