BADU JET Smart, Инструкция по эксплуатации и установке

Страница: 29 / 72

07.05.2008 TB-b bta badu jet smart_engl.indd
29
2.6 Safety instructions relevant for maintenance, inspection and assembly work
It shall be the plant operator’s responsibility to ensure that all maintenance, inspection and
assembly work is performed by authorized and quali
fi ed personnel who have adequately
familiarized themselves with the subject mat ter by studying this manual in detail.
Any work on the machine shall only be performed when it is at a standstill, it being imperative
that the procedure for shutting down the machine described in this manual be followed.
Pumps and pump units which convey hazardous media must be decontaminated.
On completion of work all safety and protective facilities must be re-installed and made
operative
again.
Prior to restarting the machine, the instructions listed under „Initial Commissioning“ are to be
observed.
2.7 Unauthorized alterations and production of spare parts
Any modi fi cation may be made to the machine only after consultation with the manufacturer.
Using spare parts and accessories authorised by the manufacturer is in the interest of safety.
Use of other parts may exempt the manufacturer from any liability.
2.8 Unauthorized modes of operation
The reliability of the machine delivered will be only guaranteed if it is used in the manner
intended, in accordance with clause 1 - General of this manual.
The limit values speci fi ed in the data sheet must under no circumstances be exceeded.
Cited Standards/Norms and other Documentation
DIN 4844 Part 1 Safety marking; Safety symbol W 8
Supplement 13
DIN 4844 Part 1 Safety marking; Safety symbol W 9
Supplement 14
3. Transport and intermediate storage
To prevent damage to and loss of detached parts, open original packing only immediately before
the installation.
4. Description
BADU Jet smart is a counter-swim unit which can be installed in every swimming pool.
A powerful jet pump is connected by means of a suction and a discharge line with the
fl ush-mounted plastic jet housing in the pool wall (no risk of injury as no parts protrude into the
basin).