Badger Meter ModMAG M2000, Руководство пользователя по установке и эксплуатации, Страница: 17 / 56

Programming Page 15/51
MID_M2000_BA_02_1807
5.1 Quick setup
The M2000 amplifier provides you with a quick setup utility that allows you to quickly
set most of the important parameters like flow units, totalizer units, full scale flow and
low flow cutoff settings.
Flow Units Flow units let you select among the flow units mentioned below. Flow
units are automatically converted into the selected unit.
Totalizer Unit This parameter establishes the units of measure for the totalizers:
Full Scale Flow
This parameter sets the maximum flow the system is expected to
measure. This parameter has influence on other system parameters.
These parameters include: Frequency output and current output.
In terms of flow velocity, the meter’s limit are from 0.1 to 12 m/sec.
Moreover the values for Low Flow Cut-off and limits monitoring depend
on Full Scale Flow.
The full scale flow is valid for both flow directions.
Note: If the flow rate exceeds the full scale setting, an error message
indicates that the configured full scale range has been exceeded.
Unit Unit
LPS Liter/Second GPM Gallons/Min.
LPM Liter/Minute GPH Gallons/Hour
LPH Liter/Hour MGD MegaGallon/Da
M3S Cubic meters/Sec. IGS UKG/Sec.
M3M Cubic meters/Min. IGM UKG/Min.
M3H Cubic IGH UKG/Hour
F3S Cubic Feet/Sec.
MID
MegaUKG/day
F3M Cubic Feet/Min. LbM Pound/Min.
F3H Cubic Feet/Hour. OPM Ounce/Min
GPS Gallons/Sec. BPM Barrel/Min
Unit Unit
L Liters UKG Imperial Gallons
HL HectoLiters MIG Mega Imp. Gal.
M³ Cubic Meters Lb Pounds
CFt Cubic Feet Oz Fluid Ounces
USG U.S. Gallons Aft Acre Feet
MG MegaGallons BBL Barrel