Badger Meter HR-LCD Pulse, Руководство по программированию

Страница: 6 / 24

IR Head Bracket
IR HEAD BRACKET
To facilitate reading and programming multiple registers, the IR head bracket is recommended . The bracket is easy to attach
and remove, and allows hands-free alignment of the programming cable IR head with the register IR port .
Attaching the Bracket to a Register
1 . Open the register lid .
2 . With the bracket guide pointing to the register lid hinge, slide the bracket onto the register so the guide fits on both sides
of the register hinge ( Figure 1 ) .
Push gently to make sure the bracket guide is completely seated against the register hinge, and you can see the IR port
through the bracket opening as shown in Figure 2 .
OTEE:
N
Moving the encoder lid up and down while sliding the bracket on helps to move the bracket into the
correct position .
Figure 1: Slide bracket onto register
Figure 2: Bracket attached to register -IR port visible
3 . Place the optical head of the IR cable in the bracket with
the nubs on the back seated in the slots of the bracket . See
Figure 3 .
This placement facilitates correct alignment between the
IR head and the register IR port . The register is ready for
programming .
Figure 3: IR head inserted
Removing the Bracket from a Register
To remove the bracket, hold the register with one hand and pull the bracket gently with the other hand, straight off the
register . The bracket should pull off with little resistance .
Page 6 May 2018 REG-PM-02658-EN-01