Bad Boy REBEL Series, Руководство по обслуживанию

Страница: 17 / 34

PAGE 17
SERVICE SECTION
SECTION 11: HYDROSTATIC SYSTEM
The hydro reservoir tank on the Outlaw Rebel model is
located just behind the seat, on each side of the frame.
Notice the “full cold” line at the bottom of the tank. Use
only 20W-50 motor oil in this tank. Conventional or
synthetic oil may be used.
THE FOLLOWING MAINTENACE IS TO BE
PERFORMED ON A LEVEL SURFACE.
Outlaw Rebel transaxles hold 4 quarts of 20W-50 motor
oil each. Bad Boy Hydrostatic Oil is recommended.
Transaxle service is recommended after the first 50 hours
of use; then at intervals of 250 hours. Hydro-Gear® brand
oil filters are recommended, use of other brands could
void the warranty.
CHANGING YOUR HYDRAULIC OIL AND FILTER
HYDRO-GEAR 4400 TRANSAXLE
1. Place an oil drain pan (12” or more in diameter
and 8 qt. capacity is optimal) beneath the oil
filter. Remove the oil filter cover from the
transaxle to drain the oil. Remove the O-ring from
the cover and discard the O-ring.
2. After the oil has drained from the transaxle,
remove the oil filter from the transaxle housing.
3. Install a new filter and a new O-ring onto the filter
cover and install the filter cover. Torque the filter
cover to 16 – 25 ft.-lbs.
4. Fill the transaxle with new 20W-50 motor oil
through the hydraulic reservoir (Fig. 7) until it
reaches the cold fill line on the tank.
5. Drain the old oil filter of all free-flowing oil prior to
disposal. Place used oil in appropriate containers
and deliver to an approved recycling collection
facility.
6. Proceed to the purge procedure.
Neutral
Bypass
Valve
Fig. 7
Fig. 8
Fig. 9
Fig. 10